A priming bulb is essential for the proper functioning of a boat’s engine. You should not take it lightly if you want to sail safely. For a sea angler, it is important to check that the bulb is working properly. Here are a few points to bear in mind in this respect.
The importance of a baiting bulb
A primer bulb is an important element for a vessel because of its usefulness for the engine. Its main role is to fill the carburettor of your boat. This means that you will not have any problems with the amount of fuel when you are on the water. Normally, this accessory is used to draw the fuel through the appropriate line.
The bulb can be primed manually if necessary. All you need to do is access the engine location to do so. You will only have to press the primer a few times to properly mix the air with the fuel. In any case, this accessory should work by itself if it is of good quality and in good condition.
Why doesn’t a primer bulb work?
Like all parts of the boat, a priming bulb like all parts of the boat, a carburettor may not work in some cases. This may be due to a problem with the bulb or the fuel lines. The fuel line can also have an impact on the proper functioning of your bulb. Also note that the fuel line can let in too much air if it is cracked or hardened.
You may have a problem with the boat’s carburettor drawing fuel. You will also need to ensure that the air filter is working properly to get the most out of your primer bulb. A plug in the tank can also cause you problems.
A bulb as a diagnostic tool for your boat
As you might expect, a bulb can be used as a diagnostic tool for your fishing vessel. The accessory acts directly on the fuel supply system. You can then use it in case the engine loses power and even stalls. Specifically, the primer bulb will force fuel to the engine.
You can check the air intake in the system if the fuel refuses to rise despite the bulb’s operation. You can then check the accessory to ensure that your engine is supplied with fuel and power. You can then fish with peace of mind even in the open sea.
Check whether the bulb is flattening or hardening
Have you noticed that the bulb remains flattened after starting the motor? Note that this kind of problem can also occur after handbaiting. In any case, this means that the accessory is clogged. It is also possible that your bulb is malfunctioning. The product may have problems with the valves.
It may also be that the attachment does not harden at a certain time. This may be caused by a downstream leak at the bulb. You can also check the carburettor float, which may be stuck.
